Pattern hacks

Entrechat hack: long sleeves

Entrechat is designed to have small cap sleeves, but I think an elbow or even full-length sleeve also works very well for this design. It could be great for chillier spring or fall days, or to use over a summer dress if it's a bit cooler in the evening (or if the A/C is blasting!).

Entrechat knitting pattern by Frogginette Knitting Patterns

Here are my notes about how I made this variation based on the main Entrechat knitting pattern, which is available here.

First a note about extra supplies: You will need a set of dpns of the same diameter as your main (circular) needle to work the sleeves in the round (unless you prefer to use the magic loop technique). You will also need a bit more yarn than indicated in the pattern since you are adding sleeve length. I would guesstimate that you will need anywhere from 50 to 150 yards extra depending on the size you are working and sleeve length you want to knit. 

The beginning of the pattern can be followed as written until Page 3 of the pattern, where it says "Repeat Rows 3 and 4 for the raglan increases until you have the following stitch count."

You simply ignore the stitch counts that are immediately following this statement, as well as the next two sentences, instead working rows 3 and 4 until you get the stitch counts given at the bottom of page 3 (they are bolded).

Then, on the next WS, instead of binding off the sleeve stitches as indicated, you place them on hold using two pieces of scrap yarn (so, purl to the end of that WS, then slip both sets of sleeve sts onto holders, removing markers).

Then, you can follow the pattern as written to finish the body of the shrug.

Once you are done with the body, it's time to work the sleeves. Place the held sleeve stitches onto your dpns, making sure they are evenly distributed.

Then, joining new yarn at the underarm (leave a yarn tail about 8" or 20cm, which you will later use to thread a needle to close up any holes/gaps), you pick up and knit two stitches from the edge of the underarm area. Place a marker between those two stitches and then knit all the sleeve stitches. Then, joining in the round, knit your sleeve stitches in the round for approximately 1" or 2.5cm. 

At that point, work a decrease round: Slm, k1, k2tog, knit until 3 sts remain, ssk, k1.

Continue working in the round in stockinette, working a decrease round every 2 inches or 5cm. When you are 1" shy of your desired sleeve length, alternate working a purled round and a knitted round to produce garter ridges. When you have three ridges, knit one more round and then bind off purlwise (this will produce your final garter ridge.)

Voila!! A sleeve!  Do the same to work the second sleeve and you're all done!

Note: Sleeve length can be easily customized depending on what you need: short sleeves, elbow length, long sleeves. Simply measure the child's arm from the underarm to where your want the sleeve cuff to be. As a reference you can also consult the standard sleeve lengths provided by the Craft Yarn Council for babies and children.

Entrechat knitting pattern (sleeve hack) by Frogginette Knitting Patterns
Entrechat knitting pattern (long sleeve hack) by Frogginette Knitting Patterns

By the way, I am running an Entrechat KAL in my Ravelry group from June 1 to June 30! Join us, it's going to be fun!

Plus, there's 30% off both my Entrechat and Madame Entrechat patterns using the code "ENTRECHATKAL"until June 10th so don't miss out! There will be TONS of prizes: yarn, notions, patterns from many indie designers... To see the entire sponsor list, check out the second post in the Club Frogginette KAL thread)

Don't forget to use the hashtag #EntrechatKAL on your Ravelry project or social media so we can all see your contribution!

Entrechat hack: two-colors

Over the years some of my favorite projects that knitters have made from my Entrechat pattern were ones involving two or more colors.

Two-color Entrechat by Frogginette Knitting Patterns #malabrigo

I think using two colors works so well for my Entrechat pattern: it underlines the unusual construction and makes the textured band really pop.

I decided to make a two-tone Entrechat using two Malabrigo Rios colorways: Water Green as the main color and Teal Feather as a contrasting color:

Here's a basic how-to:

First, a word of warning: you have to be willing to weave in a few ends! I made this using intarsia, which means that for the rows where I had contrasting color on both ends of my knitting, I used two separate balls of contrasting color yarn, one on each end, and the main color yarn for the middle.

- So before you start, wind up a small ball (about 1.5 to 2 inches - that's about 4-5 cm in diameter) from your main contrasting color (CC) yarn ball, which you'll use for the intarsia bits.

Two-color Entrechat shrug by Frogginette Knitting Patterns #malabrigo

- Cast on your project using the larger ball of CC yarn and follow instructions until you have your 4 garter ridges from the cast on edge. Cut CC yarn.

- On next RS row, switch to the main color yarn (MC) and follow the pattern until the sleeve stitches are bound off. Cut MC yarn.

- Join CC (larger ball) to pick up the stitches along the raglans and until you are ready to start the "Work Body" section.

- To work the textured band:

RS: K4 in CC (from the larger ball), join MC and work as explained in the pattern to 4 sts from end of row, leave MC hanging at the back of your work and join CC from the separate small ball, k4, (it will seem like you have a big gap where you joined the yarns but this will be fixed later when you weave in the ends).

WS: K4 using the smaller ball of CC, then leave CC hanging and pick up your MC (crossing/wrapping it around the CC to close the gap) and work to 4 sts from end of row, leave MC hanging and pick up CC from the larger ball (crossing/wrapping it around the MC) and k4.

- Keep working the textured band rows in this way -- you might need to untangle your three balls of yarns once in a while -- oh the joys of colorwork ;)

- When you reach the part in the pattern where you are given the length of the textured band, work the following RS in CC using the two balls of CC yarn and leaving the MC hanging (you can "carry it" at the back of your work, just twisting it with your working yarn as you encounter it).

- When you have worked the two garter ridges and you are ready to work the increase row, work the first 4 sts in CC using the larger ball of yarn, then pick up your MC to do the increases and switch to the CC from the smaller ball for the last 4 sts. Continue in this way using the three balls of yarn until you reach the given measurements, but instead of ending on a RS row as instructed, end on a WS row. Cut the MC yarn and the CC yarn from the smaller ball of yarn.

- On the next RS: using the CC from the larger ball of yarn, knit one row. Then work the ridges with the buttonhole according to the pattern.

- Last but not least: Weave in all those ends neatly.

TA-DA! A lovely two-color Entrechat!!

Two-color Entrechat shrug by Frogginette Knitting Patterns #malabrigo

By the way... I will be hosting an Entrechat KAL in June! I will announce the details soon.

Tutu Top Hack: ties instead of button closure

My daughter is three. At this age, she is naturally verrrry particular about many things, not the least of which is clothing. She loves purple, pink, and black. She has a fondness for tights and rain boots. All pretty par for the course. But the one thing that has been a real challenge is that she is deathly afraid of buttons. Not on other people's clothing (she loves playing with my own buttons) but on her own clothes, it's a huge no-no. I think maybe her hair got tangled up in one at some point, and she is now firmly anti-button. 

I knew I wanted to make her a Tutu Top for the Easter / Spring Dress KAL (you can still participate by the way! Here's where it's happening). It's such a quick and comfy design. It's very play-friendly, lasts forever (you can make it with a bit of room to grow, and still use it as a tunic many months down the line), and IT TWIRLS!! So, a no-brainer. 

BUT, it was designed to close at the back with a button (fastened with an I-cord loop closure.)

Tutu Top knitting pattern closure hack

I knew that wouldn't fly. Thankfully it's extremely easy to turn this type of closure into simple ties.

Tutu Top closure hack

The way I did it is I started off creating a 3-stitch regular I-cord:

Cast on 3 stitches using two dpns (of the same size as used in the pattern for the attached I-cord of the neckline), slide these 3 sts to the other end of the dpn without working them, then, without turning your work, knit them (make sure the first stitch you work is nice and tight). Slide the 3 stitches again to the other side of the needle without turning your work and knit the stitches once more, keeping things nice and tight. Keep going until you have an I-cord that's about 8 inches or 20cm long.

Then start working the attached I-cord along the neckline as explained in the pattern (naturally skip the "cast on 3 sts" part). Then, work the unattached I-cord on the other of the back neck opening, as explained in the pattern, but this time make it 8 inches or 20cm long, so that it matches the other side. And of course, no need to form a loop or anything :) Voila! Easy-peasy:

And here's a happy girl in her new Tutu Top!

Tutu Top by Frogginette Knitting Patterns
Tutu Top by Frogginette Knitting Patterns
Tutu Top by Frogginette Knitting Patterns

If you'd like to make your own Tutu Top, you can find the pattern here.

For mine, I used Malabrigo Rios in the Lotus colorway for the body, and the "tutu" part is made with some fuschia-colored Lana Grossa Silkhair (which is a bit too thin, but it worked out fine).